Specifications and models of photovoltaic support steel tie rods

How many rods are in a photovoltaic axis bar?

The axis bar is composed of 11 shaft rods. Photovoltaic panels are installed on the photovoltaic support purlins. The reciprocating rotation (tilt angle) of the axis bar allows the panel to receive direct sun. The structure is symmetrical with respect to the axis bar, and the axis bar provides a fixed axis for torsional deformation.

What are the characteristics of a cable-supported photovoltaic system?

Long span, light weight, strong load capacity, and adaptability to complex terrains. The nonlinear stiffness of the new cable-supported photovoltaic system is revealed. The failure mode of the new structure is discussed in detail. Dynamic characteristics and bearing capacity of the new structure are investigated.

What is a supporting cable structure for PV modules?

Czaloun (2018) proposed a supporting cable structure for PV modules, which reduces the foundation to only four columns and four fundaments. These systems have the advantages of light weight, strong bearing capacity, large span, low cost, less steel consumption and applicability to complex terrain.

What is a flexible PV mounting structure?

Flexible PV Mounting Structure Geometric Model The constructed flexible PV support model consists of six spans, each with a span of 2 m. The spans are connected by struts, with the support cables having a height of 4.75 m, directly supporting the PV panels. The wind-resistant cables are 4 m high and are connected to the lower ends of the struts.

What is cable-supported photovoltaic (PV)?

Cable-supported photovoltaic (PV) modules have been proposed to replace traditional beam-supported PV modules. The new system uses suspension cables to bear the loads of the PV modules and therefore has the characteristics of a long span, light weight, strong load capacity, and adaptability to complex terrains.

How many pillars does a photovoltaic support system have?

The tracking photovoltaic support system consisted of 10 pillars (including 1 drive pillar), one axis bar, 11 shaft rods, 52 photovoltaic panels, 54 photovoltaic support purlins, driving devices and 9 sliding bearings, and also includes the connection between the frame and its axis bar. Total length was 60.49 m, as shown in Fig. 8.