Press the energy storage button before closing the power distribution cabinet

How to shut down the power distribution cabinet in case of emergency?

If you need to immediately shut down the Power Distribution Cabinet in case of emergency, please follow the following steps: 1Please open the plastic cover of the EPO button on the control panel. 2Press the EPO button, then the main input circuit breaker will trip and stop all switch- board output. (Figure 5-7: Activate EPO Function) EPO

What should I do if my power distribution cabinet is energized?

yWhen operating the Power Distribution Cabinet in an energized state, please use safety devices (such as insulating gloves and shoes) and operate on an insulating rubber cush- ion to avoid electrical shock. There should be at least one person to give assistance. In case of an accident, you should be adaptable and seek assistance.

How to check the status of a power distribution cabinet?

The LCD monitor of the Power Distribution Cabinet can display the current system status and event logs, and allows you to set and view parameters. If the back light is not lit, pressing any button will activate it. On the initial status screen, you can view the system date and time as well as the switch- board circuit breaker status.

What happens when the power distribution cabinet leaves the factory?

When the Power Distribution Cabinet leaves the factory, the DIP switches of the cir- cuit board at the back have been adjusted according to your model. Without permis- sion, do not make changes to settings not mentioned in this manual to avoid equip- ment damage.

How does the power distribution cabinet work?

The Power Distribution Cabinet provides two smart slots that allow you to connect the SNMP card, or use RS232 interface to connect to the work- station. The six built-in dry contacts allow you to connect an external device. Infrasuite Power Management7 2.6 Appearance 2.6.1 Appearance of the Cabinet (Figure 2-1: Appearance)

Can a power distribution cabinet be removed from the installation site?

If wires come in through the bottom side of the Power Distribution Cabinet and the side pan- els cannot be removed from the installation site (such as combined cabinets), first remove the wire cover at the bottom before moving the Power Distribution Cabinet to the installation site as follows: